How the hell do you get the bolt off the rotor? It's turned at a bad angle and I can't even see if it's a phillips head, or what. Also, the valve cover gasket is pretty much shot and there's oil in all the spark plug wells, the car should still run, right? It's worked fine up until now, and I know it needs to be fixed, but the car stopped running to day and I changed the plugs, wires, and distributor cap, but I can't get the damn rotor off. I tried restarting the car with the new stuff and the old rotor, but it still won't fire. Hopefully when I get back under the distributor cap the rotor bolt will be a more manageable place. Any other ideas?94 Honda Accord rotor bolt?
just get your engine to TDC. (rotor pointing to #1) you can get the screw off from there.
it should be a phillips head.
may also be your ignitor going out.
94 Honda Accord rotor bolt?
mark the position of the distributor, and remove the 3 12mm bolts. now you can free spin the rotor to were you can get to it. Also you gotta remove the distributor because that o-ring leaks real bad, you usually replace it when you replace the valve cover. Another reason the car is not starting is the main relay. After you do all the engine work, and the car still will not start. Get a main relay.
distributor off tap the engine until the bolt faces the opening and take out. if not break the rotor and make opening with little vise grip take out. u don't have to pull distributor. if no spark try coil most of the time it's a bad coil.
Subscribe to:
Post Comments
(Atom)
No comments:
Post a Comment